Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Houston Owner’s Guide
Boral fence installation in Houston typically runs $3,500 to $9,000 for a complete run, and we install Boral-compatible panels, posts, and hardware with a written line-item price before any work starts. Most Houston homeowners discover they need us when a summer storm or a few years of clay-soil shifting finally does what it always does to fence posts: loosens them, cracks the concrete footing, or leaves a gate sagging so far it drags across the lawn. Boral’s composite fencing is genuinely tough against Texas heat and humidity, but the installation hardware, post foundations, and gate framing are what fail first, not the boards themselves.
We’re an independent Houston contractor, not affiliated with Boral. What we do stock and install is the full Boral fence line: panels, posts, rails, post caps, and gate kits, matched to your existing system. If you have a failing Boral fence part and you want it fixed right, call (254) 272-5240 and we’ll walk you through what you’re seeing before we ever send a crew out.
Which Boral Models This Applies To
Boral makes its fencing under a few recognizable names, including Boral TruExterior and the Boral Composites line, and Houston homes tend to have the tongue-and-groove composite panels paired with powder-coated steel or aluminum post inserts. The compatibility gotcha is this: Boral’s panel profile changed slightly between early production runs and the current iteration, so a post trim piece or top rail from a 2015 fence may not seat cleanly against a 2023 panel. We always measure the panel thickness and the post channel width on site before ordering anything.
On the OEM-versus-aftermarket question for Boral specifically: Boral’s composite boards carry a manufacturer warranty that you lose if you pair them with an off-brand post system that does not support their specified expansion and contraction tolerances. Composite moves in Houston heat. It expands less than vinyl but more than cedar, and the post sleeves have to allow for that. We recommend Boral-matched posts and rails for the structure, and we will tell you honestly if a quality aftermarket gate hinge is just as good as the Boral-branded one.
Styles & brands we work with
Signs Your Boral Fence Installation Is Failing
- Posts tilting at the base. Houston’s clay soil expands in wet springs and shrinks in August, and a post set with a shallow concrete collar will start leaning. The panel itself is rarely the problem; the footing is failing beneath it.
- Gate dragging on the lawn. The hinges loosen, the frame twists, and the latch stops lining up. On Boral gates, the issue is usually that the gate frame was undersized for the weight of the composite boards, and the corner brackets start to pull.
- Panels rattling in the channel. Boral panels ride inside post channels, and when the plastic corner blocks or the channel shims degrade, the panel has room to knock. You will hear it on windy days, which in Houston is a lot of days.
- Cracking at the bottom rail. Composite does not rot, but a bottom rail that was installed in contact with soil can still collect water and split when it freezes briefly during a cold snap. We see this most in neighborhoods like Meyerland and Bellaire where yards sit close to the water table.
- White chalky streaks below the post caps. That is the post sleeve breaking down under UV exposure where the cap no longer seals. It’s cosmetic at first, but it lets water into the post insert and that rust is not cosmetic.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a straight fence run with good access, a Boral fence installation or major repair in Houston typically lands between $3,500 and $9,000, depending on linear feet, gate count, and what the existing concrete footings look like. A small repair, like replacing two damaged posts and a section of panel, sits at the low end. A full perimeter with two gates and all-new footings sits at the top.
| Scope | Houston Installed Price |
|---|---|
| Post and panel repair, 1 – 2 sections | $3,500 – $4,500 |
| Half-run replacement with gate hardware | $4,500 – $6,500 |
| Full Boral fence installation, 2 gates | $6,500 – $9,000 |
The written price covers the demo of the failed section, new Boral-compatible materials, concrete footings, hardware, and the clean-up with a photo before the crew leaves. If we find the soil condition or an old underground line changes the scope, you hear about it on the day, in writing, before the work changes. Graham Stein has a rule on his jobs: no change order happens on a handshake. It goes on paper first, the same as the original scope.
DIY or Call Us?
There is a version of this project an owner can safely handle and a version that goes wrong. You can check the gate hinges for looseness, clear soil away from the bottom rail, and mark where posts are tilting. You can even tap a post plumb temporarily with a mallet and a shim to stop a gate from dragging. What you should not do is pull a Boral post out of a Houston clay footing by hand, reset it with quikrete, and expect it to hold through the next wet season. The footing depth here matters: fence posts in Houston need to be set deep enough to survive both soil heave and the occasional tropical storm gust, and a shallow DIY reset fails within a year.
If the post is leaning, the channel is cracked, or a gate is sagging, call (254) 272-5240. We’ll ask what you’re seeing, tell you whether it’s urgent, and schedule a free estimate. A written price and a covered floor before any work begins, that is where the trust starts.
FAQs
Boral composite fencing typically lasts 20 to 30 years in Houston, but the post footings and gate hardware usually need attention every 8 to 12 years because of our clay soil and humidity. The boards themselves rarely fail first; the installation does. Call (254) 272-5240 for an honest assessment of what is salvageable.
Yes, in most cases we can repair a Boral fence by replacing the failed posts, gate frame, or damaged panel sections while matching the existing board profile and color as closely as the manufacturer’s current line allows. An exact color match on a 10-year-old fence is not always possible because of sun fading, and we will tell you that up front. Call (254) 272-5240 to talk through what we can save.
Most Boral fence installations and targeted repairs in Houston take one to three days, depending on how many concrete footings need to be cut out and re-poured. Weather is the usual wildcard, and we schedule around rain days rather than rush concrete that will fail early. Call (254) 272-5240 and we can give you a realistic window for your specific run.
We carry common Boral-compatible post channels, corner blocks, gate hinges, and hardware on the truck, and we order panels and post sleeves matched to your fence’s measurements when we confirm the scope. That does mean a short lead time on panel orders, and it also means you do not pay for a guess. Call (254) 272-5240 and we’ll check inventory while you’re on the phone.
Written by Graham Stein, Owner, Elmstead Remodeling Houston at Elmstead Remodeling Houston, serving Houston and nearby areas.
